Directions
for our Votive Kit:
-
It's a good idea to coat the inside
of the molds with a mold release spray, especially on first use.
If you do not have any, you can use cooking oil or spray.
-
Weigh your wax on a scale.
Melt the wax in the pouring pot, set inside a pot of water on the stove
(like a double boiler). NEVER directly on the burner!
-
Once melted, add approx. 1-2 dye
chips per pound of wax (depending on desired shade) and stir until dissolved.
-
Next add approx. 1 oz. of scent
per pound of wax, and stir well. Some fragrances blend easier than
others, so some may require more stirring. Vanilla based oils tend
to have a more difficult time blending. If you run into a difficult
one, try adding a bit of Vybar 103 and stir very well up until you pour.
-
Check temperature with thermometer.
Once wax is approx. 170-175 degrees it is ready to pour.
-
Pour from the pouring pitcher
into your mold slowly and steadily, and fill to top of mold.
-
Once wax has set slightly on top,
insert the pre-tabbed wicks. The wax in the bottom should be thickened
enough to hold the wick tab in place. Center and straighten the wicks.
-
Allow wax to completely harden.
Wax will form a well or a "sink hole" in the center. Do a second
pour, filling well to top of original fill line. Occasionally check
to make sure wick remains centered and straight (it can pull to the side
while hardening). Allow wax to completely harden again.
-
Remove candles from molds.
They should come out easily, but if you should have any trouble, put them
in the freezer for awhile and try again.
-
It is best to allow your candles
at least 1 week to cure before test burning for optimal fragrance throw.
Always test burn your candles before selling, and make sure to include
a caution label on each one!
|
Instruction
Sheet: